BMW Hydraulic Power Steering Gear Box

  • ZF Hydro Power Steering Gear Box

    BMW E23, E24, E28, E31 and E32

    Rebuild Service Includes Leak repair and Lash setting

    I do not rebuild/repair the deep Internal parts (i.e. I am not going to mess with those pesky 23 small ball bearings, or the internal PTFE Teflon o-rings). I have now done 20 hydros, and have not found any that were worn out.

    The main large Gear Set has not shown any visible wear. One 635 had 277,000 miles.

    E23/E24/E28 Rebuild is $340.00

    E31/E32 Rebuild is $374.00

    Will send quote for return shipping and insurance 

  • BMW E28 Hydro Steering Box

    I can repair the leaks in your steering hydro.

    I will replace all of the rubber seals to eliminate the exterior leak points. More info

  • ZF Power Steering

    BMW E3, E9 and E12

    Rebuild process it to install all new seals and 3 Needle Bearings, the same sizes as BMW.

    I do not get into the internal inner workings of the Hydro. The only way to tighten up loose steering is by resetting the Lash, this is the way BMW has to solve this problem. I reset the lash as part of my replacing the exterior perimeter seals.

    Rebuild is $430.00 + will send quote for return shipping and insurance

  • Non Caged vs. Caged Bearing

    BMW E3, E9, E12

    The original non caged bearings are difficult to remove as they are pressed in.

    I have a removal tool designed just for this purpose, but it is not effective on every occasion.

    When the edge fractures off, its a bitch to remove, and in a blind hole it requires extreme measures, bottom of photo.

    BMW did not design this Hydro to be rebuild-able, but I can do it.

  • Rebuild and Re-lash

    Please try and empty any fluid inside and place into a kitchen trash bag to contain any escaping fluids. Also, try and plug the in/out ports and please double bag.

    Please make sure that the Hydro is not allowed to move around, inside the box, and that the padding is stiff enough (not compressible) to not allow the Hydro to move around and puncture the plastic bags.

    Its like two 10 lb bowling balls trying to mate and escape the box.

  • Shipping Info

    The Cast Iron Hydro, return ship weight is about 25-26 lbs. (11.34 -11.79) Kilos. with box and ATF, no padding.

    The Hydro will not fit in a USPS Flat Rate Box. So I use a 13x9x8 return box.

    Send me your address via e-mail and I will quote return ship via FedEx Ground Home Delivery with Tracking.

    To get a ship quote from FedEx I will need an address, (new rules online).

    On the heaver items FedEx is less than the USPS

    Include your phone # as FedEx requires a phone #, for Home Delivery.

Pricing

BMW POWER STEERING HYDRO GEAR BOX 

Rebuild Service:

Power Assist Hydro

E3, E9 and E12 Rebuild is $430.00 + will send quote for return shipping and insurance

E23, E24 and E28 Rebuild is $340.00 + will send quote for return shipping and insurance 

E31 Rebuild is $374.00 + will send quote for return shipping and insurance 

Only for 850’s from 9/1991 to 6/1994 with M70 motor

E32 Rebuild is $374.00 + will send quote for return shipping and insurance 

Only for 735 and 750

Optional repaint add on: $170 - media blast to remove paint and rust from cast iron, then paint satin black. I do not paint aluminum, I polish aluminum

Previous
Previous

A/C Compressor

Next
Next

Mechanical Steering Gear Box - BMW 2002